what size tabs yall running? Im gonna be installing soon

Kracker Jack

Kracker Jack

God
Im definitely gonna be going with Electric LENCO tabs. Bu what size is everyone running? I have read the size chart but just curious if guys are running a slightly bigger tab. Thanks for the info in advance.
 
12x12 probably larger than necessary... but got a good deal in a new old set of Bennett hydraulics. Only takes a touch.
 
Bennett 120M I believe 10x12....... more than enough for 150 hp weight motors.....
Rates for 17-23' boats.

If heavier 200 + hp, might go a little bigger, or not.

Bigger / wider is better to a point.
Reason - less drag, that's right LESS drag with wider tabs. Smaller tabs and you'll run them deeper most of the time, creating more drag. Bigger tabs ( wider) and you get more response with less drag angle. Toooooo big, and you get too much sensitivity.

Got it sir ?
 
Still probably gonna do tabs, just hate drilling all those holes. I like the look of bennet premier line and they will make you a custom size. Lencos seem like they would be easier as far as less to rig.
 
bradford said:
Still probably gonna do tabs, just hate drilling all those holes. I like the look of bennet premier line and they will make you a custom size. Lencos seem like they would be easier as far as less to rig.
Click to expand...

It's worth it......don't sweat the holes.....do it right and no worries.
 
ive got the m120 sport tabs on mine too.

with a 350 and a bravo leg theyre on the small side... usually run with them 2/3's down if its not calm, if it is then 1/2
 
You must log in or register to reply here.
Back
Top