Fill hole with what?

S

steplift20

God
We just had to drill a 1 inch hole on the transon on my sons polar for his new fish finder and I'm not sure what to use to fill it We don't want to buy a can of insulation for just a very small hole What else can we use Thanks
 
above or below water line?

Whats in the hole? What is the space to be filled?

Is it the cable above water line? Fill it with 5200 or 4200 or silicone and put one of those stainless cable feed covers on to make it pretty.
 
Do like Skunk said.
Get a clam shell cover large enough to cover the hole after filling it with 5200, 4200 or a premium grade silicone.
You may need to replace the cable later in time.
 
1" is a big hole for a cable. I'm guessing you had to get the plug through. Was it wood or composite cored? I'd coat the inside of the hole with epoxy before putting in a filler. Might even be able to get a transom drain tube to fit
 
phatdaddy said:
1" is a big hole for a cable. I'm guessing you had to get the plug through. Was it wood or composite cored? I'd coat the inside of the hole with epoxy before putting in a filler. Might even be able to get a transom drain tube to fit
Click to expand...

Definitely do what's stated here (coat raw core material with epoxy or a reduced resin) then fill with 5200 and clam shell over hole.
 
For large holes you can also make 5200 go further and fill easier by mixing in some sawdust. (The coarser the better) Squeeze 5200 into a mixing cup, add no more than 1/3 by volume sawdust. Mix thoroughly so all sawdust is coated with the 5200. Trowel into the hole after coating the inside of the hole with epoxy. Hold in place with plastic wrap and scotch tape until the filler has set up so it doesn't run out. Remove the plastic wrap, cover with the clamshell and you're good to go. :beer:
 
use a hole saw and cut a plug out of another piece of wood. Cut a key hole in teh plug for the transducer. Epoxy seal both the plug and the hole in the transom, slip the plug over the cable, silicone the outside of teh plug and slide it in the hole, Put a clam shell over it. If you ever need to remove the plug you can knock it out
 
You must log in or register to reply here.
Back
Top