Replaced wobble roller hardware

dmoore

dmoore

Senior Member
I had been wondering why the boat wouldn't come off the trailer like it had previous. Upon further inspection found several rollers at rear gang that were binding up. I knew there were some rusted washers & hog rings just didn't realize it was that many. Replaced ALL washers/hog rings at rear gangs as well as front. Also, one of the saddles would not pivot as it should. Removed the rusty U-bolts and replaced saddle pivots. All rollers are in excellent condition, so they were left alone.

eIdtgJEm.jpg


qrBP1W7m.jpg
 
Last edited:
I have to replace one rear roller hardware. I got hog rings,s.s washers plus original galvanized washers and had to get the bushing. Item number 1002.61 in case you wanted to see it. Load rite trailer 2012.
What make trailer do you have?
 
Linebacker from Zepp is pretty good stuff also, reminds me of Cosomoline that the military used to put on their stuff,kinda messy.

Salt usually wins this battle,no matter what u do
 
Fluid film, its like a thin grease that is in a spray can. Buy it at home depot in same isle as wd40. Washes off with pressure washer. I use it on boat trailer, motor in winter and spray it all over the underside of my pickup in winter. Its some kind of oil from sheep's wool I think.
 
You must log in or register to reply here.
Back
Top