Console rebuild Lowrance 12”

Leffe · Thursday at 3:19 AM

About to rebuild the console so the 12” will fit.
But it will be a challenge making room for the gauges. RPM, tilt and tank. I can either make the hole console a bit wider or add something on top. What do you think?

phatdaddy · Thursday at 7:32 AM

Looks like a challenge. Not sure what engine you have, anyway to use NEMA to import gauge info and display on screen?

Leffe · Thursday at 8:15 AM

That was a very good idea but my suke is from 2013 and i think need som adaptors etc.
I cut it up and will make it 7cm wider and also move it 2cm to the left

Blue_Runner · Thursday at 9:10 AM

Sounds like you know what you are doing - unlike me LOL. Definitely subscribed to this thread, can't wait to see your end product!

Leffe · Thursday at 11:48 AM

Blue_Runner said:
Sounds like you know what you are doing - unlike me LOL. Definitely subscribed to this thread, can't wait to see your end product!

No i am totally beginner at this

But if there is a will….

Did my first fibre glassing yesterday, just a sample with two layers of 300gr chop strand on a polyurethane board. Did the other side this morning. Hard as a rock now. I Will try tomorrow if it holds my weight ~90kg