Search results

That might have been me. I have an 84 center console with a 90hp inline 6 and it would do 25 - 30 mph depending on the load I had in it. I just rebuilt the engine and am still breaking it in. Now at 3500 rpms she will do 19 mph, cant wait to get the break in done so I can open it up again. Yes...

30 gallons of 25:1, gottcha covered, even installed an above deck tank to keep from having to double the 60 gallons in my inboard tank.

Yes those marks are a reflection. You had me worried for a minute but if you look close you will see a redish line down the middle, that is the reflection from my engine hoist. I have more invested in the tools than I would like to confess to but I wanted to make sure it went together right...

Thats all the pictures I got for now.

Some where along the way I forgot to take pictures but here it is back on the mid section and wired up.

Inspecting the rings. All OK, none broke on the way in.

Installing the upper and lower bearing end caps.

Putting all 6 pistons in at the same time was pretty easy with the ring compressor kits.

With new piston pin bearings and washers.

Now the pistons go on.

Piston pin tool.

Center main bearings.

Rods onto the crank.