Search results

I can't get my kayak into Fort Pickens for a straight shot offshore to my snapper hole. I have an annual pass too.

Well my buddy needed to borrow my boat trailer. So the 18 Fish has been sitting on it. Got it unloaded and was checking tire pressure and the right front tire moved a bit when I put the air chuck on it. Pulled the cap and nut and the bearing fell onto the ground in pieces. Checked the others...

To hell with 300. Rig up the 350 SCI Verado.

Congrats. That is on my bucket list. Whether by kayak or V20.

We have been tilting the motor up and down by putting the trim motor wires straight to the power and ground. No problems there. He bought the relay box of ebay for what we thought the motor was. Then I discovered it was a 74 200. Can we change the relays to higher amp relays? Or should I go with...

It's got the three wire trim motor. Constant ground. Then a wire for up and a wire for down. I have the relay box shown above and it does not work. The trim motor barely makes a sound.

Yes we tried to use the old relay box. But this Outboard is a 1974 200. The relays would not push enough current to run the motor. The trim motor would barely spin. So now I am trying to figure how to make this dam thing work right. We might just run dual Mercury trim tilt solenoids.

Crab island!!!!!!

But how fast are you going with 1050hp running wot?

This engine is a 200649S. Its supposed to have a single solenoid. Will it hurt to wire. It like the 80s with relays?

Good luck on the sale and that is a good price. The 160 ought to fly!

60mph is the new 50mph. Your in old times. Better speed up or get left behind.....

The manual relief valve was five turns out.......

I do not believe its electrical. We are hooking the trim motor wires straight to the battery right now because there is no black solenoid box. He just got one and I will be installing it tomorrow. He did say the previous owner replaced the trim motor. Could it be a problem with the installation...

Happy Birthday MJ.

Thanks Tsubaki, and MJ!

Happppppppy Birthday Spare.

Its a 1986. Hedge we are putting the motor wires to the battery. Ithas no black box yet..

A good friend just bought V6 Evinrude 150 with 200carbs. It lowers and trims down. But will not trim or tilt up. The electric trim motor does run. If we pull up the motor the trim rods will extend but will not push the motor. Its got fluid. What are we missing?

Here's another pretty cool idea for a console design.