Search results

ok so its doable is what im seing and even a 5.7 or 5.0 is doable engine tag says motor and drive no more than 950 lbls together im gonna get it weighed out both ways but probably go 305 or 5.0 whatever you wanna call it

posted a few more pics i posted a few more pics just click on a photo and it will take you to my album

trailer trailer is pretty sweet needs a few thing but it is nice today i removed some stringers in whole pieces was thinking about tracing them so i didnt have to refigure them out is this a good idea onle the first froot were rotten at the bottom but the floor was bad and im all for reolcing...

new pics from today

slowly getting there i finally got enough man power to get the cuddy top of with out cutting it up but now its raining and work is kicking this winter so i havent had time to do much more beings im doing it outside i knew i should have built the garage first but couldnt pass up this boat

smoke i would have to figure out how to make those side mounts mine is front and rear mounted

what was in it it had a 250 but the guy i got it from is a lil shady supposed to be a new block and internals looks clean but just not to sure

no i have a big glass one that just gets screwed to the hull i have to replce the plywood in it to its rotten in the back and over the cuuddythis boat was just not well maintained and they just screwed whatever they wanted to where ever they wanted to and i went and joined the hull truth to get...

same here i have a note book i write everything down in and ill check out those sites also and keep up with my pics

you cant see it in the pics i have removed all the rub rail and screws whoever did it before did a crappy job the cap is cracked a little and the screws were just held by the shell so im gonna put a 2x2 all the way around the inside of hull for better hold power of the screws me and my brother...

can i use a 292 straight six out of a old chevy truck as long as i change the freeze plugs and use marine gaskets and dirtibutor and can i still use the same out drive

good one i dropped alot of oh craps over board

i was gonna make some storage trays under the passenger side dash into the cuddy i would do away with the cuddy but keeping it for the kids to have a spot to rest and for storage of other boat stuff the under the seat thing is cool to i can always trim down my mounts already have seats taht are...

floor reply thinking about it now you have a good idea on the simple floor and that cuddy step is kinda in the way from port to starboard side and if i wanna fish that bad and keep them i have the big a** white cooler that hold a ton of stuff so it would be a good idea for me to do that

fish boxes can someone tell me the best way to get them out with out damaging them and my cuddy step down

floor layout this is best pic i can get at the moment my top isnt all the way off cant get the manpower to do it and have no where to put it at the moment

ok i see mine is made a lil diff i have no cap unless it rotted away and how do i get the fish boxes out without messing up my step into cuddy to lhe left is the step down and middle is the box and far right is the other box

yea the ol i/o controls dont mix done tried that route

stringer question on your old stringers were they straight to the outer shell mine were an a sixteenth to an eighth off the shell so far im stuck on what to do about the two boxes and getting them out:clap:looking good :beer:

tank reply kracker i did a nuber on them but with your pic i can put a board in there like that and put the floor to it andafter before the final glass rip some low slope triangles to look similar to the slope the have sounds like a plan to me