Recent content by usmma2013

Hey guys, I got a new to me Wellcraft (25 Coastal...) to add to the fleet and she's got twin '88 Johnson 140s. Motors have 600 original hours and run excellent. However, engineer in me still wants to do a full tuneup. These are my first engines with oil injection - My question is for the guys...

Hey ya'll, Finally got my cuddy interior built up and finished the way I want, now just have to find cushions. Anyone know if they are available or if any other manufacturers or similar sized boats have similar dimensions and will work? I'd like to hear if anyone has made their own as well and...

evinrude 140 crossflow troubles (W/PICS) Hey guys, Evinrude 140 here, 1984 year. I went to start the motor for the 1st time this season. She fired up after several cranking and priming sets. Ran for a few minutes then pulled the plugs to inspect, the stbd (looking fwd) bank of cylinders has...

Anyone know if the v20 tshirts/sweatshirts seen in the galleries are still available? I'd be interested in at least a shirt and sweatshirt. Reading back through the forums i think chesapeake724 was the one who made them.

Hey guys, I have a johnson 140 that has an acceleration problem. It'll run great at idle, 600rpm in gear, but when you hit it it'll rev up to maybe 2k an thats it. Kinda sounds like its bogging. pumping the bulb does nothing. I just rebuilt the carbs, the gas is new, compression is 110 on one...

hey guys, Just finished rebuilding an evinrude 140 crossflow v4. The powerhead on the engine was scored and needed a hone, I had a spare powerhead with good compression. I gave it a light hone and new rings and used all the carbs, fuel pump, and electronics from the original engine. I started...

Hey guys, My v20 came with a 140 evinrude bubbleback that needs a rebuild(Scored piston). I have a extra powerhead already bored 030 over and I was going to hone and deglaze the cylinders and give it new rings. I have all the parts and was going to rebuild it and put it back on..before a...

For the Wellcraft's new stereo, since I use my IPod the majority of the time instead of installing a cd/fm/am receiver I've decided to go with a 4 channel amp and wire a permanant input for the ipod on the dash. Question is, can I get away with one of these cheaper brands like Pyle or Boss...

Hey guys! I recently bought a '79 V20 that is in very good condition but I have a few mods I would like to do. I won't actually get to the boat for another few weeks, so this will have to be that kind of terrible thread with no pictures. I just want to float some ideas by and see what other...

One of the boats I'm looking at will probably need a new floor, how much of a job is it with a V20? I've redone the floor on a runabout before and it wasn't too hard, just cut the old floor out, cleaned up foam and new foam (stringers were fine!) and glassed in new marine ply. It took me two...

Hey guys, I have an Evinrude 100hp 1972 thats in great condition needs a switchbox. Sellin for parts the rest of the electronics are in great condition and lower unit was just rebuilt with new wires and solenoids (hydroelectric shift). These are pretty old but some parts are hard to find so...

Hey there, I'm looking for a older V20 in Virginia or surrounding areas. Preferably a project (missing motor, bad transom, etc) because I don't have much money but If your trying to get rid of one in good condition, that works too! I have a Glassmaster 18' speedboat with an inline Merc 115 in...