Recent content by MIKETTURBO

I have genuine new OMC flywheel 584350.$650.00 lists for over $1000 OMC stator 584981 $250.00 OMC Viper prop 176627 $300.00 ultra HPF lube 775301 $9 a qt. fuel separator filters 502905 $8 each starter drive $20 aftermarket stator $175.00 tilt trim gauge $20 water press gauge $20 THIS IS...

Sold.

hi guys,I remember seeing someone move floor scuppers to through rear wall.the The new scuppers have a flat edge,so as to lay close to the floor when mounted horizontally.Then the floor holes get glassed over.anybody else see this done?

hay guys, my 94 jonny 175 has a problem with the alarm going off.sometimes as soon as i turn the key on,hot or cold.steady tone! i ck. all the oil level & fuel. i'm thinking of a short in the control box,i bang on the box & wiggle the wires going into it as well as by the motor.still going...

My 1994 Johnson 175, won;t go over 2000 RPM,9 MPH. (what a long ride).I have no alarms going off,tried pumping the primer bulb while underway.no difference. I was racing the motor up at the throttle linkage on the motor while hooked up to the garden hose in the driveway,I did'nt rev it up too...

does anybody the degree of the starting bow rail fitting(by the windshield)on my 86 V20 cuddy? looks like 10 deg. to me but i need to be sure.

thats right $100.00 new never used.for 1994 175.HP.don't know what else it fits.

some guys say the under gunnel rod boxes go through the opening & mount inside the opening.are you kidding,i'd need to be a magican to get them inside,mine were mounted on the outside surface.I tried to put them inside & they dont fit in there.what gives?

1986 v20 cuddy,full enclosure,1994 175 johnson ocean runner,low hrs.2 bateries,hyd steering,ff,gps,vhf,& am/fm cd player.todd helm seat,ss wheel.2000 bilge pump.bow remote spotlight,led spreader lts.ss prop.very well maintained.cleaned & flushed with salt away after every use.runs great.40 mph...

Selling my wellcraft V20.1986 with a 1994 Johnson 175.flushed after every use,low hrs.many extras with trailer.exellent cond.all well cared after.$6000.oo cash.still in water.firm on price.I don't need to sell,just not enough time to use it.rock solid transome. Boat is in staten island NY...

how can i bend ss. tubing for a railing around the motor well,maybe mount a couple of rod holders to or a cutting board,any ideas?

does anyone know if an o-ring belongs on the top of the shaft.It looks like a groove the ring will fit in.its right under the splines,my johnson manual dosent show it,or the parts manual.but the omc waterpump kit shows it & includes one that fits.oh yeh,there wasent one on there when i took it...

changed my trim motor today,1 bolt broke & i had to drill & tap.then i changed the water pump.JONNY 175. & 1 bolt broke,theres about 3/16 of the bolt sticking out.i tried heat & visegrips no good.i'am trying so soak it in oil overnight.any suggestions? i hate drilling & tapping.

found a new way to cover the V,then just tarp it.

i can't post in classafied for some reason.. e mail me 4 pics. 94 175 johnson,full enclosure,onboard chg.stereo,ff.gps.hyd steering. very well kept & maintained boat/trailer.6800.00 firm.i just don't use it enough. miketturbo@si.rr.com