lumberslinger178

609-790-6226 and email bgreene@rocktenn.com

Lum - one of the V guys told me you have the " little etec 200hp" on your boat.
If that's true, appreciate if you'd please tell me about it - I figure that motor might be good for my V21 ..........some day. - It's lighter than the 200 HO, and lighter than most all 200's I've noted.
How does it run ? Idle, cruise, what's your WOT speed ? Fuel consuption ?
Thanks

Bennett Greene
B.Greene90-6226
609-7

Hey LUMBER I noticed the picture on your profile of your boat and was just curious if You could send me a better picture of your v20 so I can see how you set up your bimini and curtains on your center console.

Thanks, Mat

Kenny anything on the place for guys to stay yet? I have not looked since talking with you so let me know if you think I should start looking again

Kenny
Didn't you use cetrol on your teak? I got some but mine is the gloss (overcoat) did yo use just this or did you use wha goes on before this?

thanks Lee 252-336-2588 aka garagenc

Ken call me or give me your ph # I need to talk to you about getting yr room, they are sold out.
252 336 2588 or cell 252 312 6970

Hey Ken, check out this link - it's a retired chemical engineer talking about using antifreeze to kill rot. Go down to Dave Carnell's post. I think it has lots of applications in our work as well as on the boat. http://forum.woodenboat.com/showthread.php?7967-Git-Rot

Hope all is well with you - a little slow here, but still breathing.

not a word ken, do not believe i have a number for him it was on my saved messages and then we went to the new V site and it was gone

I have not seen or heard anything from him either??

Hi Pete sorry I didnt get back to ya sooner just saw this message, that sounds like a t&m job to me

Hey Kenny, what's up? I hope you are well. Just curious.....what do you charge per foot w/ the crown molding? This particular job is 6" poplar crown....288 ft, 60'of that is in a foyer w/ 18' cieling, the remainder [228 ft.] is going throught the downstairs at 9'. It will be coped in all corners. McMansion type home ["new victorian"] any ideas? Thanks , peter