Recent content by Leffe

Job Done! (Just some switches left). Turned out pretty good.

Lesson learned and note to self, put on alot of gel coat befors sanding, alot! Because you will sand through… I couple of layers more and some sanding, then i am done. Have to find a good switch panel though. That and an USB-A and C Will make it really good. Lucky for me summer is late in...

Yeah that was my backup plan, but it’s all right!

A very good question. I have not thought about that actually. Put on lots of gel coat during the week and sand the whole thing today. Have to check it ASAP!

Alot of fairing and sanding done. Plan was to gel coat it last weekend but found a 1inch/2,5cm gap on the lower part so had to fix that. A set back with a couple of days…

Thanks! I have watched alot of videos about fibre glassing on YT during the winters and now it finally happened. Next project (after the season) will be de foredeck which is a bit soft. I will probably paint it with some kind of double coat. Just have to choose which kind of ”white”, not the...

Getting closer

Have good feeling about this 🙂

No i am totally beginner at this 😆 But if there is a will…. Did my first fibre glassing yesterday, just a sample with two layers of 300gr chop strand on a polyurethane board. Did the other side this morning. Hard as a rock now. I Will try tomorrow if it holds my weight ~90kg It bugs me that...

That was a very good idea but my suke is from 2013 and i think need som adaptors etc. I cut it up and will make it 7cm wider and also move it 2cm to the left

About to rebuild the console so the 12” will fit. But it will be a challenge making room for the gauges. RPM, tilt and tank. I can either make the hole console a bit wider or add something on top. What do you think?

hello first post here. Old thread but still. The rail is great when you are fishing up there!