Recent content by Big Lar

Pic 1 INSIDE CABIN PIC 2 ANOTHER VIEW LOOKING INSIDE CABIN PIC 3 TORN BIMINI PIC 4 AND 5 TRIM (HOW CAN I CLEAN

Still getting a few pics up PIC 1 DASH BOARD NO ELECTRONICS PIC 2 MATES DASH PIC 3 GAS TANK COVER OFF PIC 4 CABIN INTERIOR PIC 5 THE ROTTEN BIMINI

Is it possible to post more than 5 pictures at a time? Every time i preview, i lose the pics 1ST PIC CAPTAINS SEAT AND CONSOLE 2ND PIC VIEW OF CONSOLE AREA NOTE FLOOR 3RD PIC NOTE FLOOR 4TH PIC MATES SEAT AND OPENING TO CABIN

Has anyone installed a windlass on a cuddy. My problem is the pulpit is not long enough to install the windlass on it and still have room for the anchor shaft. Because of the sliding access panels, cannot find another place to locate the windlass. Do i need to go to a shorter shaft anchor...

BEEN WORKING ON THE BOAT AND PARTYING. GOT THE STORAGE SEATS IN PLACE, NEED TO FINISH, TRIM AND PAINT. DECK PAINTED PRELIM PLUMBING FOR THE LIVE WELL ONE. MADE A "CABINET" TO GO OVER THE LIVE WELL THAT WILL HAVE A SMALL SINK AND SALT WATER WASH DOWN. TOOK THE INSIDE CAPTAINS SIDE PANEL...

I have a bunch of pictures in PHOTOBUCKET AND DO NOT KNOW HOW TO TRANSFER THEM TO THIS FORUM. THEY ARE SET TO GO WITH CAPTIONS ETC. THEY ARE ALL "BEFORE"PICTURES. I AM SURE IT IS NOT THAT HARD, BUT I HAVE TROUBLE SPELLING "GEAK" THANKS IN ADVANCE

I am in the process of installing a windlass. The instructions say to run #6 wire from the battery to the 80 amp breaker and continue wiring. My question is if currently I have # 6 wires going into a fuse block, can I go from the main input line to the breaker thus avoiding the 15' wiring...

hope this helps. the pictures are a Little blurry, but I cannot do them again as I have started the cutting to make them for my boat.

Just took possesion of a 82 20' Wellcraft cuddy with a 2001 150 Merc. the boat is in great condition only needing a non skid paint job on the deck (done), a new Bimini top, detailing, new decals etc. I am in the process of making it "My boat". I have added trim tabs, will be installing a...