Prev
I lightly clamped the two 2x4 pieces to the gunnel and made a mark across the top of the two pieces then cut the angle on the table saw.
Next
Prev
End view of the schmoo board and it fits real nicely without any hardware or screws. Works great too!
all done in place with a nice snug fit by adding a couple of pieces of duct tape to the inner 2x4 pieces. Also the tape stops the wood from scratching
100 1856
I lightly clamped the two 2x4 pieces to the gunnel and made a mark across the top of the two pieces then cut the angle on the table saw.
"schmoo board" bait cutting board made of PT plywood. Drilled five 1/2" holes thru so schmoo can drain off the boat.
Finished and ready to use. I wanted two seats in the back of the boat for bottom fishing seating, but I did not want them permanently mounted to the f
Wal-Mart seat($24.99) and swivel base
Next
S

I lightly clamped the two 2x4 pieces to the gunnel and made a mark across the top of the two pieces then cut the angle on the table saw.

  • Media owner Shawsee
  • Date added
There are no comments to display.

Media information

Category
V20 Steplift
Album
Shawsee, 1976 Cuddy
Added by
Shawsee
Date added
View count
1,061
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top