Prev
Finished and ready to use. I wanted two seats in the back of the boat for bottom fishing seating, but I did not want them permanently mounted to the f
Next
Prev
100 1856
I lightly clamped the two 2x4 pieces to the gunnel and made a mark across the top of the two pieces then cut the angle on the table saw.
"schmoo board" bait cutting board made of PT plywood. Drilled five 1/2" holes thru so schmoo can drain off the boat.
Finished and ready to use. I wanted two seats in the back of the boat for bottom fishing seating, but I did not want them permanently mounted to the f
Wal-Mart seat($24.99) and swivel base
100 1848
swivel seat base made out of PT plywood and PT 2x6
Next
S

Finished and ready to use. I wanted two seats in the back of the boat for bottom fishing seating, but I did not want them permanently mounted to the f

  • Media owner Shawsee
  • Date added
There are no comments to display.

Media information

Category
V20 Steplift
Album
Shawsee, 1976 Cuddy
Added by
Shawsee
Date added
View count
1,106
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top