|
|
swivel seat base made out of PT plywood and PT 2x6
Viewed: 1015 times.
|
100 1848
Viewed: 1022 times.
|
Wal-Mart seat($24.99) and swivel base
Viewed: 1002 times.
|
Finished and ready to use. I wanted two seats in the back of the boat for bottom fishing seating, but I did not want them permanently mounted to the floor. So if we are trolling for stripers, blues , or albies, I don't bring them because they tend to get in the way of the open space that's needed when trolling. Simple enough and no holes in the deck.
Viewed: 1049 times.
|
"schmoo board" bait cutting board made of PT plywood. Drilled five 1/2" holes thru so schmoo can drain off the boat.
Viewed: 964 times.
|
I lightly clamped the two 2x4 pieces to the gunnel and made a mark across the top of the two pieces then cut the angle on the table saw.
Viewed: 1004 times.
|
100 1856
Viewed: 998 times.
|
all done in place with a nice snug fit by adding a couple of pieces of duct tape to the inner 2x4 pieces. Also the tape stops the wood from scratching the gunnel.
Viewed: 968 times.
|
